Using The Stick Vac; Maintaining The Stick Vac; Removing And Refitting The Dirt Container - Vax Blade 2 Max User Manual

When less than 20% charge is remaining
the bottom light will flash red indicating
the battery is running low and charging is
required (Fig. 7 /3).

Using the stick vac

WARNING: The brushbar in the
!
powered head constantly rotates
when switched on. Never use the
powered head on one spot for an
extended period of time as the
brushbar may damage the floor
surface. Always turn the powered
head brushbar off when cleaning hard
floors. To prevent any damage being
sustained, test on an inconspicuous
area of the flooring first.
CAUTION: If the brushbar in the
powered head has been
obstructed, the brushbar motor
protection sensor may have been
activated. The brushbar will stop
and the light on the powered head
will illuminate red (Fig. 18 ). To reset
switch the brushbar and stick vac
off, remove the powered head from
the reach wand/handheld and clear
any obstruction. Wait 1 minute before
refitting the powered head tool,
switch the stick vac on and press the
brushbar ON/OFF button.
1. Place your foot on the powered head
(Fig. 8 /1) and pull the handle backwards
to recline (Fig. 8 /2) .
2. To switch the stick vac on, press the
ON/OFF button located on the handle
(Fig. 9 /1). The On/Off button and battery
level indicator lights on the handle will
illuminate (Fig. 7 /2).
3. To increase suction for particularly
dirty areas that require additional cleaning
boost mode can be activated (Fig. 9 /3).
4. To switch the brushbar on, press the
brushbar ON/OFF button (Fig. 9 /2).
The light on the powered head and the
brushbar ON/OFF light will illuminate
when the brushbar is on and the brushbar
will constantly spin. Press the brushbar
ON/OFF button again to turn the
brushbar off.
NOTE: The powered head brushbar
should be ON for carpets and OFF for
hard floors. Constant use of the boost
mode and brushbar will reduce the
battery run time.
5. All of the accessories, including the
powered head can be attached directly
onto the handheld (Fig. 10 ) or the reach
wand. The crevice tool and dusting
brush can be used for hard to reach
places and at different heights for above
floor cleaning.

MAINTAINING THE STICK VAC

WARNING: Always switch off
!
the stick vac and unplug from the
charger and mains before carrying out
any maintenance or troubleshooting.

Removing and refitting the dirt container

1. Push down the latch on the dirt
container (Fig. 11 /1) to release, tilt and lift
to remove the dirt container from the stick
vac. (Fig. 11 /2).
NOTE: Before refitting, if the lid of the
container with separator has been
removed for cleaning make sure the
separator has been locked into place
(Fig. 13).
13