Safety; Power Supply; Brushbar - Vax Blade 2 Max User Manual

Safety

This stick vac can be used by
children aged from 8 years and above
and persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowledge if
they have been given supervision or
instruction concerning use of the stick
vac in a safe way and understand the
hazards involved. Children must not
play with the stick vac. Cleaning and
user maintenance must not be made
by children without supervision.
Keep fingers, hair and loose clothing
away from moving parts and openings
whilst using the stick vac.
Don't use the stick vac if it has been
dropped, damaged, immersed in water
or left outdoors.
Don't handle the charger plug or
use the stick vac with wet hands.
Don't use the stick vac charger if
the charger cord or plug is damaged.
Don't unplug the charger by pulling
on the charger cord.

Power supply

WARNING: For the purposes
!
of recharging the battery, only
use the detachable supply unit
provided with this appliance.
Don't charge the stick vac outdoors,
or leave the charger connected to the
mains when not in use.
Don't use the stick vac with the
incorrect charger as this may result
in damage or injury to the user. The
correct charger information is listed on
the ratings label.
Always use the charger supplied
with the stick vac. If charging the stick
vac through an extension cord, use
only CE approved 13amp extension
cords, non-approved extension cords
may overheat. Care should be taken to
arrange the extension cord as it can be
a trip hazard.

Brushbar

WARNING: The brushbar in
!
the powered head constantly
rotates when switched on. Never
use the powered head on one
spot for an extended period of
time as the brushbar may damage
the floor surface. Always turn the
powered head brushbar off when
cleaning hard floors. To prevent any
damage being sustained, test on an
inconspicuous area of the flooring
first.
CAUTION: If the brushbar in
the powered head has been
obstructed, the brushbar motor
protection sensor may have been
activated. The brushbar will stop
and the light on the powered head
will illuminate red. To reset switch
the brushbar and stick vac off,
remove the powered head from the
reach wand/handheld and clear any
obstruction. Wait 1 minute before
refitting the powered head tool,
switch the stick vac on and press
the brushbar ON/OFF button.
3