Table of Contents
Advertisement
Quick Links
GreenLyte-MV Excel
2. PRODUCT OPERATION
2A. CW + LINEAR MODULATION / CONTROL VERSION
Connect Binder connector to back of laser
- CW Mode
To operate laser in CW mode the Red, Black and Blue leads should be connected to the
following:
1.
Red lead: +3.3 Vdc to +6 Vdc
2.
Black lead: 0 Vdc
3.
Yellow lead: Not connected
4.
Blue Lead: V supply if not using as enable switch
- Linear Modulation function
To linearly modulate the laser any modulation signal up to 200 kHz (dependant on diode)
with an amplitude of 0 V to +1 Vdc can be applied to yellow lead.
1.
Red lead: +3.3 Vdc to +6 Vdc
2.
Black lead: 0 Vdc
3.
Yellow lead: input modulation signal (0 Vdc to +1 Vdc)
4.
Blue Lead: V supply if not using as enable switch
- Linear intensity control
Alternatively the yellow lead can be used for a linear power control function. In this situation,
the laser power is determined by a voltage applied to the yellow lead, 0V turning the laser off
and +1 Vdc giving maximum power, with linear trend between. (See linear intensity graph)
1.
Red lead: +3.3 Vdc to +6 Vdc
2.
Black lead: 0 Vdc
3.
Yellow lead: Input control voltage (0 Vdc to +1 Vdc)
4.
Blue Lead: V supply if not using as enable switch
User Guide
1. INTRODUCTION
Thank you for purchasing the GreenLyte-MV
Excel laser. These lasers emit a green uniform
line. You will have one of the following two
versions:
• CW + Linear intensity / modulation control
version
• CW + TTL modulation control version
If you have any problems or require help when
using the GreenLyte-MV Excel please call us
on +44 (0)1495 212213 or contact your local
representative.
Cwmtillery Industrial Estate, Abertillery Gwent. NP13 1LZ
T: +44 (0)1495 212213 F: +44 (0)1495 214004
E: sales@globallasertech.com W: www.globallasertech.com
Advertisement
Table of Contents
Related Manuals for Global Laser GreenLyte-MV Excel
Summary of Contents for Global Laser GreenLyte-MV Excel
- Page 1 • CW + Linear intensity / modulation control version • CW + TTL modulation control version If you have any problems or require help when using the GreenLyte-MV Excel please call us on +44 (0)1495 212213 or contact your local representative. 2. PRODUCT OPERATION 2A.
- Page 2 - Enable Switch An on/off switch function is available via the blue wire. Applying 0 V will switch the laser off whilst applying Vsupply leaves the laser on. A TTL switch can be utilised via this lead. If not using this function please connect the lead to the V supply.
- Page 3 3. FOCUS ADJUSTMENT The laser will be tested and shipped to the nominal working distance requested at time of order. Should you need to adjust the focus please follow the simple instructions below: Turn the dial at the back of the laser (see diagram B) Turn clockwise / anti clockwise until best focus is achieved.
- Page 4 firmly clamps the laser and prevents movement against shock and vibration. 8. PRODUCT WARRANTY AND REPAIR If your product develops a fault within 12 months from the date of purchase Global Laser will repair / replace the product. If you wish to return a faulty product contact your local representative or Global Laser to obtain a RMA (Return Material Authorisation code) and return to the address below.
Need help?
Do you have a question about the GreenLyte-MV Excel and is the answer not in the manual?
Questions and answers