Table of Contents
Advertisement
4. Slide the pull rod (5) to the left under slight pressure to keep the play
5. Position the block (4) with the roller (6) against the control cam.
6. Tighten the screw (7).
7. Check the setting and correct it if necessary.
13.4 Setting the cutting pressure
FIg. 52: Setting the cutting pressure (1)
(1) - Screw
FIg. 53: Setting the cutting pressure (2)
(3) - Block
(4) - Roller
66
inside the mechanics of the thread cutter at a minimum.
③
④
①
(2) - Thread-pulling knife
⑤
(5) - Control cam
Service Instructions 667 PREMIUM - 03.0 - 01/2018
Thread cutter
②
Advertisement
Table of Contents
