Prepare Door And Jamb - Honeywell 8832101S User Manual

PREPARE DOOR AND JAMB

NOTE: For installation on doors with pre-drilled holes skip to page 4.
1. TEMPLATE
a. Cut out template printed on page 20 of this Manual
(Figure 1a).
b. Fold template and place on door 36" (915mm) from
the ground as marked (Figure 1b).
2. MARK THE DOOR FOR DRILLING
b. Mark center hole on door edge through guide on
template for 1" (25mm) latch bolt (Figure 2a).
a. Mark center hole on door face through guide on
template for 2-3/8" (60mm) or 2-3/4" (70mm)
backset (Figure 2b).
3. DRILL AND CHISEL DOOR
a. Drill 2-1/8" (54mm) hole through door face as marked
for lock set (Figure 3a).
b. Drill 1" (25mm) hole in center of door edge for
Latch Assembly (Figure 3b).
c. Insert Latch Assembly in hole keeping it
parallel to face of door. Mark outline and remove latch
(Figure 3c).
d. Chisel 1/8" (3mm) deep or until latch face is flush
with door edge (Figure 3d).
NOTE:
template and press until it is flush with door edge.
4. MARK AND DRILL DOOR JAMB
a. Mark center hole on edge of jamb even with the center of the Latch Bolt on door edge. (Figure 4a).
b. Drill 1" (25mm) hole 1-3/16" (30mm) deep in door jamb on center mark (Figure 4b).
c. Outline outside edges of Strike Plate (Figure 4c).
d. Chisel 1/8" (3mm) deep for Strike Plate or until flush (Figure 4d).
e. Install Strike Plate using two 3/4" (19mm) screws provided (Figure 4e).
Figure 4a
For Drive in Latch, drill hole size indicated on
Figure 4b Figure 4c Figure 4d
2
Figure 1a Figure 1b
Figure 2a Figure 2b
Figure 3a Figure 3b
Figure 3c Figure 3d
Figure 4e