INSTALLING INTERIOR ASSEMBLY
9. ATTACH THE CONTROL WIRE TO THE INTERIOR ASSEMBLY
a. Use care to attach the Control Wire male plug to the Interior Assembly female socket connector (Figure 9a).
b. Do not force the Control Wire male plug into the Interior Assembly female socket connector (Figure 9b).
c. The Control Wire male plug has two alignment tabs on the smooth side of the plug which is the top of the plug
d. The Control Wire male plug is inserted with the smooth side up into the Interior Assembly female socket
connector (Figure 9d).
10. ATTACH THE INTERIOR ASSEMBLY TO DOOR
a. Position the Interior Assembly over the tailpiece and push the Interior Assembly against the door (Figure 10a).
b. Using two 5/16" (8mm) screws and one 1" (25mm) screw, attach the Interior Assembly to the Mounting Plate.
DO NOT OVER TIGHTEN SCREWS (Figure 10b).
5/16" (8mm) screws
1" (25mm) screw
NOTE: Lock and unlock using Interior Knob to see if
the latch is opening and closing easily.