Advertisement
TO SET SELF-CLEAN
CYCLE:
1. Close oven door. Press the CLEAN pad. The time
display will show (---). See Fig. 1. You may need to
press slightly on the door.
Fig. 1
2. Press the UP or DOWN arrow pad to set the desired
length of clean time. Clean
time
is normally
3
hours.
You can change It between 2 and 4 hours,
depending on how dlrtythe oven Is..See
Fig. 2. The
door locks automatically after the controls are set.
The display will show "LOCK" when door locks.
TO INTERRUPT
A CLEAN
CYCLE:
1. Push CLEAR/OFF.
Follow
InstrucUons
under "WHEN
A CLEAN
CYCLE IS FINISHED."
TO SET
DELAYED
SELF-CLEAN
CYCLE:
1. Close oven door. Press the CLEAN pad. The time
display will show (--).
See Fig. 1. You may need to
press slightly on the door.
2. Press the UP or DOWN arrow pad to set the desired
length of clean time. Clean
time
is normally
3
hours.
You can change it between 2 and 4 hours,
depending on how dirty the oven Is. See Fig. 2. The
door locks automatically after the controls are set.
The display will show "LOCK" when door locks.
3. Press the STOP TIME,
4. Set the Ume of day when you want the clean cycle to
end. See Fig. 4,
The control will calculate when to start clean cycle time.
Fig. 2
You can push the STOP TiME
to find out when the
cycle will end.
Push the CLEAN
pad to return to
countdown.
WHEN
A CLEAN
CYCLE
IS
FINISHED:
t. Walt until the LOCK display goes out.
The oven
temperature must drop to s safe level before the door
can be opened. See Fig. 3.
WAiT UNTIL LOCK GOES OUT
Fig. 3
If you cannot open the door Immediately after the word
LOCK goes off, walt about one minute and try again.
Fig. 4
Note'. When selecting a stop time for a delayed clean
cycle, you must allow Ume for the 2-4 hour clean
time.
Your oven light should be OFF during a self-clean cycle
to prolong the life of the bulb.
CLEANING
TIPS
REMOVAL
OF PACKAGING
TAPE
The safest way to remove adhesive left from packing
tape on new appliances, to assure no damage Is done to
the finish of the product, Is an application of household
liquid dlshwashlng detergent, mineral oll or cooking o11.
Apply with a soft cloth; DO NOT use a plastic pad or
equivalent.
Wipe dry and then apply any appliance
polish to thoroughly clean and protect the surface. This
procedure Is also safe for the face of microwave doors
and other plsstlc parts.
NOTE:
"rhe plastic t ape that is not removed from
chrome
trim on range parts CANNOT
be
removed
if baked on.
13
NESCL07-2
Advertisement
