Connect The Xplornet Hub 2.0; To Your Personal Wireless Router - Xplornet Hub 2.0 User Manual

Connect the Xplornet Hub 2.0

to Your Personal Wireless Router

Modem 1 Computer
Only connect to your Personal Wireless Router if you do not wish to use
Wi-Fi through the Xplornet Hub 2.0.
Disconnect your computer from the Xplornet Modem (Satellite) or
1
Power Adapter (LTE and WiMAX).
Unplug your Modem or Power Adaptor from the electrical outlet, wait
2
30 Seconds then plug it back in.
Plug one end of one of the yellow cables into the LAN port on the
3
Modem or Power Adaptor and the other end to the red Xplornet
Hub 2.0
Using the other yellow cable, connect one end into any of the four
4
yellow Xplornet Hub 2.0
port on your Personal Wireless Router.
For Xplornet Home Phone Customers Only
5
If you do not have an Xplornet Home Phone, please continue to Step 6.
Connect your telephone by attaching one end of the grey RJ-11 cable
to the green Xplornet Hub's
telephone base unit.
Connect the small black power adaptor cord into the Power port on the
6
Xplornet Hub 2.0 and then plug the other end of the cord into a 120 volt
household outlet.
Power on your Xplornet Hub 2.0 by pressing the On/Off button on the
7
side of the unit.
Please wait for approximately 10 Minutes for the Xplornet Hub 2.0 to
8
complete software upgrading before using your Wi-Fi. When the
Xplornet Hub 2.0
indicators are solid or flashing Green you can use your Wi-Fi Internet.
10
2
WAN port.
Broadband,
X P L O R N E T H U B
Xplornet
Hub 2.0
7
On/Off
Modem
3
4
6
LAN ports and the other end to the WAN
Phone1 port and the other end to your
Internet, and
U S E R G U I D E
Phone 1 Port
5
Personal
Xplornet
Wireless
Home Phone
Router
WLAN LED