Connect The Xplornet Hub 2.0 To A Computer - Xplornet Hub 2.0 User Manual

Connect the Xplornet Hub 2.0 to a Computer

Modem 1 Computer
If you wish to use your Personal Wireless Router for WiFi with your Home
Phone service, see next page.
Disconnect your computer from the Xplornet Modem (Satellite) or
1
Power Adapter (LTE and WiMAX).
Unplug your Modem or Power Adaptor from the electrical outlet, wait
2
30 Seconds then plug it back in.
Plug one end of one of the yellow cables into the LAN port on the
3
Modem or Power Adaptor and the other to the red Xplornet Hub 2.0
WAN port.
Using the other yellow cable, connect one end into any of the four
4
yellow Xplornet Hub 2.0
Computer.
For Xplornet Home Phone Customers Only
5
If you do not have an Xplornet Home Phone, please continue to Step 6.
Connect your telephone by attaching one end of the grey RJ-11 cable
to the green Xplornet Hub's
telephone base unit.
Connect the small black power adaptor cord into the Power port on the
6
Xplornet Hub 2.0 and then plug the other end of the cord into a 120 volt
household outlet.
Power on your Xplornet Hub 2.0 by pressing the On/Off button on the
7
side of the unit.
Please wait for approximately 10 Minutes for the Xplornet Hub 2.0 to
8
complete software upgrading before using your Wi-Fi. When the
Xplornet Hub 2.0
indicators are solid or flashing Green you can use your Wi-Fi Internet.
8
2
Xplornet
Hub 2.0
7
On/Off
3
6
LAN ports and the other end to your
Phone1 port and the other end to your
Broadband,
X P L O R N E T H U B
Phone 1 Port
5
Modem
Computer
4
Internet, and
U S E R G U I D E
Xplornet
Home Phone
WLAN LED