Cisco Catalyst 6880-X Installation Manual page 27

Installing the Switch
Step 6 Install all eight 10-32 or 12-24 screws (four on each side) through the cable guide mounting holes, rack-mount
L bracket holes, rack post holes, and into the clip nuts to secure the cable guides and the chassis to the rack
post. Tighten the screws securely.
Step 7
Secure the chassis using four screws through the holes in the L bracket and into the rack post holes.
Figure 21: Installing the Cable Mount Guides
1
What to Do Next
After installing the chassis in its location, complete the installation process by following these procedures:
• Connecting the chassis to system ground. See
• Installing and connecting the power supplies to source power. For information on how to install and
cable power supplies, see the
• Connecting to the switch console port. See
• Connecting to the uplink ports.
• Powering-up the chassis and verifying the installation. See
page
OL-30827-02
10-32 or 12-24 screws
Installing Power
Installing SFP and SFP+ Transceiver Modules, on page 31
33.
Establishing the System Ground, on page
Supplies.
Connecting the Switch Console Port, on page
Verifying Switch Chassis Installation, on
Catalyst 6880-X Switch Hardware Installation Guide
Rack Mouting the Chassis
28.
30.
27