Table of Contents
Advertisement
Cheetah 9 Installation Guide, Rev. B
Setting the SCSI ID jumpers
Use the J6 jumper block to set the SCSI ID (Figure 11). To
change the SCSI ID, install jumpers on the appropriate pins as
shown in the illustration. Optional connections to switching cir-
cuits in host equipment are provided on J1 auxiliary to set the
SCSI ID (see Figure 12).
Jumper Plug
(enlarged to
show detail)
SCSI ID = 0 (default)
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
SCSI ID = 8
SCSI ID = 9
SCSI ID = 10
SCSI ID = 11
SCSI ID = 12
SCSI ID = 13
SCSI ID = 14
SCSI ID = 15
Figure 11. Setting the SCSI ID on model "W" and "WD"
drives
W/WD drives section
J2
Pin 1
J6 [1]
Pin 1
J6
End
Note:
[1] Do not remove
cover from pins
13 through 20
(darkened area).
W/WD drives
43
Advertisement
Table of Contents
