Table of Contents
Advertisement
20
Initial setup information
The general information beginning on this page applies to all of
the Cheetah 9 drive models. After reading the general informa-
tion topics, refer to the appropriate drive-specific section listed
below for additional information about configuring and installing
your particular model.
Drive models
ST19101N
ST19101W/WD
ST19101WC/DC
General information
The following general information topics are discussed:
• SCSI ID jumpers
• Drive termination
• Terminator power
• Interface drivers and data path width notes
• Other applicable jumper options
• Providing adequate cooling
• Mounting the drive and connecting cables
• Formatting the drive
1
This mounting procedure does not apply to "WC" or "DC" model
drives. To mount a "WC" or "DC" drive, plug the drive into the
system's single connector attachment (SCA) position on the
system's back panel.
Cheetah 9 Installation Guide, Rev. B
Page
39
43
48
1
Advertisement
Table of Contents
