Start-Up - Holik SensPro Instruction For Operation And Maintenance

SensPro ® Protective gloves for firefighters with electronics and sensors
4

Start-up

4.1. Charging the accumulator
The accumulator is charged using the adapter in the temperature range of 0 °C do +30 °C. The charger must comply
with IEC 60950, IEC 61010-1 or other technically equivalent standards. Do not charge the accumulator in a space
where is a threat of explosion! First connect the adapter to a 230 V outlet and then attach the accumulator box to
the adapter. The charging process is indicated on the accumulator box by a coloured LED, which then switches off
once the accumulator is fully charged. Charging takes about 2 hours. The length of charging depends on the type
of charging adapter used.
4.2. Switching on of the glove
After connecting the accumulator to the control unit, the glove is switched on by a short press of the button on the
back of the glove (4). Switched on, the glove is set to mode 1 for measuring temperatures on the surface of the glove
using the temperature sensor. When the glove is connected properly, the accumulator is charged and the ambient
temperature is under 100 °C, the bar graph shines green and the status LED (6) is blue.
4.3. Wireless pairing with the glove
The glove can be paired using wireless communication with the SensPro ® application installed on a smartphone or
tablet. Precise pairing instructions are provided in the application instructions. The blue status LED blinks 5 times in
rapid succession when pairing is successful.
4.4. Switching off the glove
The glove is switched off by pressing and holding the button on the back of the glove (4) for four seconds. If the
gloves is not going to be used for a longer period of time, it is better to disconnect the accumulator.
8