Stanley Solis Inset 500 Installation And Operating Instructions Manual page 9

1. Ensure that the opening is suitable for fitting
of the inset stove (Fig 3 shows 500 Model &
Fig 4 shows 900 Model).
2. Ensure that the floor area is level.
3. Remove the top baffle from the firebox by
pulling it forward and lifting it up on the RHS
to allow the LHS of the baffle to drop into the
firebox so that it can be removed through the
fire door opening.
Fig.3 - Required opening Solis 500
405-450
555-585
*
Can be reduced to 375mm if OSA connection is
not fitted.
Fig.4 - Required opening Solis 900
595-640
555-585
*
Can be reduced to 375mm if OSA connection is
not fitted.
4. For the 500 model, remove the Flue
Restrictor Plate by pulling it towards the fire
door (see Figure 5) and for the 900 model,
loosen the two front spigot fixing bolts (see
Figure 6).
Fig.5
Fig.6
*
Min 450mm
5.
6.
7.
*
Min 450mm
Fig.7
8.
9
Flue Restrictor Plate
Flue Restrictor Plate
Remove the Flue Spigot by removing the
four M8 Allen Screws and washers.
Remove the Firebox Shell from the outer
casing by loosening the two M6 Allen Head
Screws and washers as shown in Figure 7
and pull the shell out from the casing.
Drop the flue liner down the chimney into the
fireplace and fit the flexi flue adaptor and
length of rigid pipe as required by flexible flue
manufactured to the end of the flue liner.
Firebox Shell Fixing Screws
Place the outer casing temporarily into its
final position to determine what length of
extension pipe is required between the adap-
tor & flue spigot. Cut the extension pipe to
the required length.