Nameplates For Hazardous Area Installations - Siemens LU-180 Operating Instructions Manual

Connecting

4.3 Nameplates for hazardous area installations

● Under certain extreme circumstances, the non-metallic parts incorporated in the enclosure of
this equipment may generate an ignition-capable level of electrostatic charge. Therefore the
equipment shall not be installed in a location where the external conditions are conducive to
the build-up of electrostatic charge on such surfaces.
● In addition, the equipment shall only be cleaned with a damp cloth. This is particularly
important if the equipment is installed in a zone 0 location.
4.3 Nameplates for hazardous area installations
Note
Always refer to nameplates on the device for device-specific approvals.
ATEX certificate on nameplate
The ATEX certificate listed on the nameplate can be downloaded from the LU180 product page
on our website http:wwww.siemens.com/SITRANSLU180.
Go to Support > Approvals > Certificates.
The IECEX certificate listed on the nameplate can be viewed on the IECEx website:
1. Go to http://iecex.iec.ch/
2. Click on Certified Equipment
3. Enter the certificate number IECEx 15.0118X
20
①
ATEX certificate
Operating Instructions, 06/2016, A5E37100674-AA
SITRANS LU180