Table of Contents
Advertisement
CAUTION!
The electrical connections must be made by suitably qualified personnel in accordance with
local regulations.
The device may be designed for switchboard mounting. During work on the switchboard, all
components must be de-energized if there is a danger of touching the energized parts (pro-
tection against contacts)!
Wiring works may only be performed in the de-energized state!
Thin cable strands have to be equipped with end sleeves!
Before switching on the device, connections and plug connectors have to be checked!
The device must be mounted in a way that it is protected against harmful environmental influ-
ences such as splashing water, solvents, vibration, shock and severe pollution and the operat-
ing temperature must not be exceeded.
5.2
Assembly Site
At least 0.5 m away from inductive and capacitive disturbance sources like contactors, relays, motors, switching
power supplies, clocked controllers, etc. In principle lay the FMAX-cable separated from power wires and keep
distance to disturbance sources. For installation near outside magnets, a minimum distance to the magnetic
tape of 100 mm is necessary.
WARNING!
Do not use the device in explosive or corrosive environments!
The device must not be installed close to sources of strong inductive or capacitive interference
or strong electrostatic fields!
5.3
Mounting of Guide Carriage
Take four M4-screws to fasten the guide carriage. .
5.4
Mounting of Guide Rail
The guide rail contains a magnetic tape and a profile rail. Factory made the magnetic tape is stick together with
the profile rail.
Take four M4-screws to fasten the guide rail. For that, there are drill hole at the ends.
NOTE!
For installation of guide carriage and guide rail pay attention to the markings on the
magnetic tape and on the sensor. A wrong installation will deliver incorrect values.
- 11 -
Technical Data
Advertisement
Table of Contents
