Advertisement
Put the emitter screen on the burner. Use (4) four 3/16"
bolts to connect the emitter screen to the burner.
Tighten the bolts.
Put the guard on the burner through the emitter
screen. Put the ends of the guard into the holes of the
STEP 5
STEP 6
burner.
Put (3) three washers on each pins of the 60mm
Put the reflector through the pins and on the washers.
Fasten the reflector with (3) three M6 castle nuts.
5
STEP 7
length.
STEP 8
STEP 9
Advertisement
