Safety Notes; Explanation Of Symbols; Connecting To The Mains - Bosch EasyAquatak 100 Original Instructions Manual

Hide thumbs Also See for EasyAquatak 100:
Table of Contents

Advertisement

Available languages

Available languages

OBJ_BUCH-3419-001.book Page 3 Thursday, October 26, 2017 10:34 AM
English

Safety Notes

Explanation of symbols

General hazard safety alert.
Never direct the water jet
at people, animals, the unit
or electric components.
Warning: High pressure jets can be dan-
gerous if subject to misuse.
According to the applicable
regulations, the appliance
must never be used on the
drinking water network without a
system separator. Use a separator as
per IEC 61770 Type BA.
Water flowing though a system sepa-
rator is considered not drinkable.
Safety Notes for pressure washer
Read all safety warnings
and all instructions. Failure
to follow the warnings and in-
structions may result in electric shock,
fire and/or serious injury.
The warning and information signs
attached to the unit provide impor-
tant information for safe operation.
Apart from the information in the op-
erating instructions comply with the
general safety regulations and regu-
lations for the prevention of acci-
dents.

Connecting to the mains

The voltage indicated on the rating
plate must correspond to the voltage
of the power source.
Bosch Power Tools
We recommend that this equipment
is only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA residu-
al current.
Remove the plug from socket when-
ever the machine is left unattended
for any period.
The electric supply installation
should comply with IEC 60364-1.
If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
If the plug is damaged, pay attention
to the following:
Plugs and sockets situated near the
work site or outdoors should be to
class IP 55 of BS 5490 to provide ad-
equate protection against ingress of
water, etc. and cable entries require
effective sealing. Rubber shrouds
should be provided over cable
glands. Drip-proof (class IP X2 of
BS 5490) plugs and sockets to
BS 4343 are suitable for use indoors
where the plug is away from the water
spray area where the appliance is in
use.
Never touch the mains plug with wet
hands.
Do not pull plug while operating the
device.
Do not run over, crush or pull the
power supply cord or extension cord,
otherwise it may be damaged. Pro-
tect the cable from heat, oil and sharp
edges.
Do not use the unit, if the power sup-
ply cord or important parts, e. g.
English | 3
F 016 L81 746 | (26.10.17)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents