Battery Percent And Charge Time - Schumacher SCF-6000A SpeedCharge Owner's Manual

BATTERY PERCENT AND CHARGE TIME

This charger adjusts the charging time
in order to charge the battery com-
pletely, efficiently and safely. The
microprocessor automatically makes
the necessary decisions. However, this
section includes guidelines that can be
used to estimate charging times.
The duration of the charging process
depends on three factors:
1. Battery State – If a battery has only
been slightly discharged, it can be
charged in less than a few hours. The
same battery could take up to 10
hours if very weak. The battery state
can be estimated by using the built-in
tester (see page 10). The lower the
reading the longer charging will take.
2. Battery rating – A higher rated
battery will take longer to charge than
a lower rated battery under the same
conditions. A battery is rated in
ampere-hours (AH), reserve capacity
(RC) and cold cranking amps (CCA).
The lower the rating the quicker the
battery will be charged.
3. Charge rate – The charge rate is
measured in amps. This charger
provides charge rates of 2A and
30A 10A. The 60A rate is for engine
start only. The 2A rate is for charging
smaller batteries such as those used
for motorcycles and garden tractors.
Such batteries should not be charged
using the 30A 10A rate. The
30A 10A rate is for charging larger
batteries. The 6000A charges at the
selected charge rate and eventually
reduces the charge rate in a con-
trolled manner. After the charging
process has started, the digital
display can be used to determine
charging progress by selecting the
BATTERY % mode.
There are some important facts to keep
in mind when charging a battery.
• When the display indicates 77%
charged, the battery has been
charged enough to start most vehicles
and has already been charged as
much as by many other battery
chargers.
• When the display indicates 85%
charged, the battery has already been
charged at least as much as by most
other battery chargers.
• The battery % shown in tester mode
is an estimate based on the battery
voltage and the Battery Council
International scale. The battery %
shown in charger mode is an estimate
of the relative charge in the battery
compared to the charge it should
have if the charging process is
allowed to complete.
• The battery % shown in tester mode
can be used to estimate the relative
charge time. The lower the % shown,
the longer the charge time. The lower
the % shown, the longer the charge
time for a given battery.
• The battery % shown in charger mode
is an indication of the relative
progress of the charging process. The
higher the battery % displayed, the
less charge time remains.
• The more a battery is discharged, the
faster it absorbs charge from a
charger. That means that the battery
% increases faster at the beginning of
the charging process than at the end.
In other words, it takes longer for the
battery to absorb the last few percent
of charge than the first several
percent.
14