Troubleshooting; General Troubleshooting - McGREGOR 7496428 Original Instruction Manual

Troubleshooting

General Troubleshooting

WARNING!
Only perform the steps described within these instructions!
Always turn off the machine and remove the plug before making any adjustment.
The following table provides solutions to common problems encountered with the mower.
Fault
Mower does not start
Motor stops
Blade fails to turn
Strange noises, rattling or
vibrations
Possible Cause
No power at mains socket
Defective on/off switch
Defective motor
Grass too long
Blade is blocked
Cut height too low
Blade blunt
Blade area blocked
Blade assembled incorrectly
Blade blocked by grass
Blade bolt loose
Blade bolt loose
Blade damaged
Customer Helpline 0345 605 2063
Solution
Check the fuse, switch,
socket, cable, wire and have
any repairs carried out by a
technician required
Set at a higher cut setting. Lift
the front wheels slightly by
pressing down on the handle
bar.
Disconnect from mains and
remove blockage
Set a higher cut height
Sharpen or replace the blade
Remove blockage
Install the blade correctly
Remove blockage
Tighten the blade bolt
Tighten the blade bolt
Replace the blade
27