Table of Contents
Advertisement
Settings
Settings
<Speaker/X'over>
Preparation:
Before making the adjustment for <Speaker/X'over>,
select the appropriate crossover network mode
according to the speaker system (2-way speaker
system or 3-way speaker system).
1
Put the unit in standby.
On the Home screen, touch as follows:
Then, on the source/option selection screen, touch
[STANDBY].
2
Display the <X'over Network> screen.
On the monitor panel, press the following buttons
at the same time:
3
Select the crossover network mode.
[2way]
Select this when 2-way speaker
system is used (front/rear).
[3way]
Select this when 3-way speaker
system is used (tweeter/mid range/
woofer).
A confirmation message appears. Touch [Yes].
30
ENGLISH
Setting the speakers and crossover
frequency
1
Select a car type (
1
), select a speaker
(
2
) (front speakers, rear speakers, or
subwoofer) to set, then location* and
speaker/tweeter size (
3
) of the selected
speaker.
A selection window appears for each setting. Select
an item, then touch [Close] to close the window.
Speaker Select
Car Type
Speaker
Location
Tweeter
X'over
Medium
• Repeat steps 2 and 3 to set all speakers.
• Adjustable items vary depending on the selected
speaker type.
• When a speaker is not connected, select [None].
• When setting the front speakers, also select the
speaker size for <Tweeter>.
* Speaker location selection is selectable only when <X'over
Network> is set to [2way].
2
Touch [X'over] to display the <X'over>
screen.
3
Select the speaker type (
1
the crossover frequency (
2
selected speaker.
X'over
Front
Rear
Subwoofer
HPF FREQ
100 Hz
Slope
-6 dB/Oct
Gain
0dB
TW Gain
-1dB
E.g. When <X'over Network> is set to [2Way]
• Adjustable items vary depending on the selected
speaker type/speaker size/crossover settings.
• Speaker types shown on the screen differ
depending on the <X'over Network> setting.
<HPF FREQ>
Adjusts the crossover frequency for the front or rear
speakers (high pass filter).
<LPF FREQ>
Adjusts the crossover frequency for the speaker
(low pass filter).
<Slope>
Adjusts the crossover slope.
<Gain>
Adjusts the output volume of the selected speaker.
<TW Gain>
Adjusts the output volume of the tweeter.
<Phase Inversion>
Activates the phase inversion for the speaker.
• To deactivate, touch [Phase Inversion] again.
), then adjust
) of the
Advertisement
Table of Contents
