Gemini FlexiPen 120 User Manual page 17

Plan
In this menu you set data on the width of the plotting paper, options for the
optimization of the plotting (to divide PLT into stripes, stripe width), pen range
optimization.
Stripe optimization: if the setting „Optimize PLT for pen plotting" is checked
the plotter will draw stripes at the sated width in the field „Stripe width". In this way you
can avoid some inconveniences such as: excessively rolling the paper back and forth,
or paper wrinkling. If you don't check this option, the plotter will roll paper back and
forth for all marker length; you will have to make sure and roll out enough paper for the
length of the drawing.
The recommended optimization stripe length is approximately 250 mm.
Optimize plotting path: if checked, the pen path is optimized to use the
shortest path without empty courses.
Plotter parameters: this is where you set the serial port where you can
connect the plotter to the computer and communication settings of the plotter with the
computer.
. In the bottom there are 3 buttons:
Default settings: click on it to load the default settings;
Accept: click on it to save all settings;
Cancel: quit;
Calibrate: plotter calibrating button.
User guide – Plotter Flexipen 120/165
17