How To Put On The Refill Inside The Device; How To Put On The 3 Ml "Jumbo" Refill Inside The Device - Gemini FlexiPen 120 User Manual

Plan

6.2 How to put on the refill inside the device:

To put on the refill you will have to unscrew the device as you can see in the above
picture.

6.3 How to put on the 3 ml "JUMBO" refill inside the device:

For the writing head you can also use a special 3 ml refill, which may be placed
directly in the case without the writing device. The advantage for using this kind of refill
is the fact that it lasts more than the others - you can print with one "JUMBO" refill for
about 500m. Another advantage would be the fact that you don't have to supervise the
plotter all the time, which must be done when you use a common refill and you know
that it depletes very quickly.
This type of refill is very easy to use. Mount the refill according to the picture
below; ensure that between the refill and the paper remains about 1.5 mm. Then
adjust the pen pressure to about 250÷300g. Test the refill writing possibilities using the
"Test" key; the test must be applied on all paper width. If the writing test is not
successful readjust the pen pressure or rearrange the refill position.
If you try to change the refill during plotting you may affect the plotting quality
because you may change the position of the writing head by accident. We recommend
you to change the refill in the LEAVE state.
User guide – Plotter Flexipen 120/165
12