Interlogix TruVision series Quick Start Manual page 2

STEP 7: For every camera you want to use
Motion to activate Event mode enable motion
detection.
Camera Setup/Motion Detection - Click
•
"Enable Motion Detection", click "Start
Draw" and drag mouse to setup motion
area (red squares are where it is looking
for motion). Click "Save."
STEP 8: For every camera you want to use
embedded analytics to activate Event mode
(Cross Line, Intrusion Detection, etc.) enable
VCA (TVN-11 Only—TVN-10 programs in the
camera).
VCA/ Cross Line Detection - Click "Enable
•
Cross Line Detection", Click "Start Draw"
and drag mouse to create Cross Line, se-
lect directionality, Click "Save."
In the Actions tab, click "Notify Alarm Host"
•
to enable push notifications for this camera
(VCA is more stable than Motion Detection
and works better for push notifications, but
walk testing line location and sensitivity is
still recommended).
STEP 9: Name the Cameras - Camera Setup/
Camera OSD - Name each camera you
choose whether or not you want to name and/
or time & date to display on the screen. Click
"Save."
STEP 10: Enable DDNS if you don't have a
static IP address - Network Settings/DDNS -
Click "Enable DDNS", type in a Host Name
(start with a letter, only letters and numbers,
no capitals, no symbols), click "Save" (not get
URL). If the name is taken it will fail and you
will need to select a different host name.
Use hostname.tvr-ddns.net to access the
•
recorder from offsite
STEP 11: Log into the router on site and set-
up port forwarding for ports 80,8000,554
(these are the defaults and can be changed in
the Network Settings of the recorder). For-
ward these ports to the same IPv4 address of
the recorder.