Sense SE-350-WT-HAND Manual page 11

Installation Tips & Guidelines
To place or replace batteries inside the SE-350-WT-HAND by taking the following steps.
Fig. 1
1. Figure 1: Unscrew the outer tube of the microphone
2. Figure 2: Insert 2 AA batteries in the battery holder, + to + and – to –.
3. Figure 3: Replace the battery holder and screw the outer tube back onto the microphone.
4. Figure 4: Push the power button OR slide the Mute button up to power on the microphone. Adjust
settings as needed. See section 8.
Once you have re-attached the microphone head, pair the wireless frequency with the wireless receiver's
frequency. Refer to section 8 for full instructions on how to pair the frequency.
Annotations
1. Power: Push to power on the Microphone, press
2. Mute: Slide up to talk and down to mute while the
microphone is powered on. Slide the Mute Button
The microphone will power down automatically
after 1, 10, or 30 minutes of muting depending on
settings selected
3. Ultrasonic Receiving Unit: Receives pairing
signals from the ultrasonic transmission unit on
the receiver
4. Battery Holder: Holds 2 AA batteries. AA sized
rechargeable batteries are also compatible.
5. LED Indicator: displays Mute and Low Battery
6. LED Indicator: displays the microphone settings
7. SET: press to change and select microphone settings, including frequency, group, channel, sensitivity,
8. : Use with the SET button to change settings
9. : Push and hold the LOCK button to lock all buttons. Press and hold to unlock after buttons have
been locked.
Support: 866.838.5052
Fig. 2 Fig. 3
PG 11
Fig. 4a
6
5
2
9
7
8
1
SE-350-WT-HAND
|
Fig. 4b
4
10
3