Inserting Bobbin - Sunbeam Domestic 70 Operating Instructions Manual

Inserting bobbin

ATTENTION:
Turn power switch to (O ) "0" before inserting
or removing the bobbin.
When inserting or removing the bobbin, the
needle must be fully raised.
- Open the hinged cover. (1)
- Hold the bobbin case with one hand. Insert
the bobbin so that the thread runs in a
clockwise direction (arrow). (2)
- Pull the thread through the slot, down and to the
left until it enters the delivery eyelet (rectangular
opening) under the tension spring. (3)
- Hold the bobbin case by the hinged latch. (4)
- Insert the bobbin case fully into the shuttle
race and release the latch. Make sure that the
metal nger ts into the notch at the top of the
race cover. (5)
13