Preparations For Use; Winding The Bobbin - Sunbeam SB1800 Operating Instructions Manual

•
Plug one end of the adapter into the DC socket on the sewing
machine, and the other end into an outlet.
•
Plug the foot control into its socket.
•
Turn the power switch on.
Caution:
Always turn the switch on off before un-plugging the
machine.

Winding the bobbin

1.
Place a spool of thread on the Spool Pin.
(Figure 1) (Make sure that the machine's
needle is not threaded at this time.)
2.
Place the metal bobbin on the bobbin winder,
making sure to insert it in the groove. (Figure
2) (Note: It is important to use metal bobbins
only. The Bobbin Case is magnetized and is
activated with metal.)
3.
Guide the thread from the Spool Pin through
the thread clamp (Figure 3) and to the bobbin.
Wind a small piece of thread around the
bobbin
clockwise.
(Figure 4)
4.
Move the
bobbin
Page 4

Preparations for Use

Operating Instructions
Figure 3 Figure 4
Sewing Machine Instructions
Figure 1
Figure 2
Figure 5