Ricoh 2045e Scanner Reference page 29

v Change Initial Mode
If you use the settings which are
displayed when modes are cleared,
reset, or immediately after the op-
eration switch is turned on as the
initial mode, select [Standard].
Select [Program No.10] when you
use the settings stored in Program
No.10 as the initial mode.
Selecting a custom size
When selecting [Custom size] as the
scan size, follow the procedure be-
low.
A
Press [Custom size] on the Scan
Size Setting screen.
B
Enter the original size with the
number keys.
Select and enter values for [X1] and
[Y1], and then press the {#} key.
C
Enter the scan starting point in re-
lation to the standard scan start-
ing point.
Select and enter values for [X2] and
[Y2], and then press the {#} key.
D
Enter the scan size (area) with the
number keys.
Select and enter values for [X3] and
[Y3], and then press the {#} key.
Depending on how the original is
positioned, the scan area will be as
follows:
Original orientation
X2 X3
Y2
Y3
Y1
X1
X3 X2
Y2
Y3
Y1
X1
X2 X3
Y2
Y3
X1
shows the face of the original.
shows the back of the original.
shows the feeding direction.
The range of possible original sizes
and scan sizes is as follows:
• Original Size
X1: 140 - 432 mm (5.5" - 17.0")
Y1: 140 - 297 mm (5.5" - 11.7")
Initial Scanner Setup
Original orientation
X3 X2
Y3
Y1
Y2
X1
X3 X2
Y2
Y1
Y3
X1
X2 X3
Y2
Y3
Y1
Y1
X1
ZHSY055N
2
19