Table of Contents
Advertisement
Additional Required Items Not Supplied with the Radio:
In addition to the supplied accessories, software and cables
supplied with the FLEX-6700R Signature Series SDR, you will
need to provide the following:
•
An HF- Receiving Antenna
•
A good RF ground.
•
Powered stereo speakers (computer type) or stereo
headphones.
•
A personal computer (PC) running Windows XP Service
Pack 3 or above. Either 32 or 64-bit operating systems
are supported.
•
A 100/1000BaseT Ethernet Access - either an open port
on your computer or on your local area network (LAN)
Ethernet switch.
2.0 MAKING THE CONNECTIONS
MAKING THE CONNECTIONS
2.0
The following steps will describe the required connections for
getting your FLEX-6000 Signature Series software defined
radio on the air.
First Steps:
1.
Carefully remove the packaged accessories and the
receiver (FLEX-6700R) from the shipping carton.
Remove the plastic covering from the radio.
2.
Identify all of the supplied accessories listed above.
3.
Place the radio in your operating position making sure it
has adequate ventilation.
Back Panel Connections
1.) Antenna - Connect an HF antenna with nominal 50 Ohm
impedence to one of the BNC receive antenna connectors
labeled ANT1 (DEFAULT) or ANT2.
Advertisement
Table of Contents
