FlexRadio Systems FLEX-6700R Signature Series Quick Start Manual page 16

Step 4. Operating Your FLEX-6700R Receiver
The SmartSDR console will be displayed with one (1) High
Definition Panadapter Spectrum Display and one Slice
Receiver tuned to 14.100.000 MHz as shown below.
To TUNE the receive slice to another frequency:
1.) Click the BAND button on the left side of the panadapter
then click the desired BAND.
2.) (PAN-EDGE-TUNE) Hover your mouse over the blue bar
in the panadapter window. Using the left mouse button, click
and hold the button while dragging the slice to the desired
frequency. Note that as you approach the edge of the
displayed panadapter, it will begin to PAN so you can see the
desired frequency segment.
3.) (DIRECT FREQUENCY INPUT) Hover your mouse over
the Frequency numbers in the Slice Panel. Click once with
the left mouse button to highlight the frequency. Type in the
desired frequency and press ENTER. Note that you can enter
frequency in kHz or MHz directly. If the entered frequency is
beyond the displayed panadapter screen an OFF-SCREEN
indicator will be displayed on the panadapter display. Simply
double-click on the indicator to re-center the panadapter to
your desired frequency.