Advertisement
F
IRES OF
Step #8
Carefully slide the beam into place on
top of the legs. Lower this gently!
Dropping it into place, even from a short
distance, risks chipping.
Check the fit, and position the legs
carefully to ensure that they are plumb
with the sides of the beam. Carefully
remove the beam once you are satisfied
with the final location of the legs.
T
I
I
RADITION
NSTALL
Step #10
P
AGE
C
NSTRUCTIONS FOR
ORVALLIS
At this point, it is good to do a dry fit of
the legs and side slips to ensure that all
parts are properly located. Position the
two legs first, then slide the slips
carefully into position to ensure that the
back face of the slips fit up against the
front of the fireplace. A small gap here is
not a problem, as it quickly disappears
into shadows. But if you properly locat-
ed the firebox, then this will not be an
issue.
Step #9
This image is looking down inside the
leg. Take one of the wooden shims
supplied in the blister pack, and insert it
between the block on the inside top of
the leg and the bracket. This will help
hold the leg against the wall.
There is a place for a second shim at
the bottom of the legs. Installing the
second shim may be done by reaching in
from the front bottom of the leg. This is
only
necessary
extremely out of vertical. Please use
your own discretion in placing the
second shim.
8
12
OF
#4008
where
the
wall
is
Advertisement
