Table Of Contents; Introduction - Bully Dog RAPID FLOW Cold Air Intake Installation Manual

Table of Contents

This instruction set outlines the installation and maintenance of the Stage 2 Rapid Flow Cold Air
Intake for all GM 6.2L gasoline powered pickups. Installation of this intake takes about 20 minutes,
requires little mechanical experience and can easily be performed in a driveway even by those who
have never installed an intake on a vechicle before.
INTRODUCTION ..........................................................................................................PG. 1
PARTS INCLUDED ........................................................................................................PG. 2
PARTS DESCRIPTION ..............................................................................................PGS. 3-7
INSTALLATION .................................................................................................... PGS. 8-18
REMOVING THE STOCK AIR INTAKE ................................................................ PGS. 8-13
PREPARING TO INSTALL THE RFI INTAKE ...................................................... PGS. 14-15
INSTALLING THE RFI ON THE VEHICLE .......................................................... PGS. 16-18
FILTER MAINTENANCE ..............................................................................................PG. 19
PREFILTERS ..............................................................................................................PG. 20
REPLACEMENT CONE FILTER .......................................................................................PG 21
TROUBLESHOOTING:
1

INTRODUCTION

TABLE OF CONTENTS
Before Calling Technical Support complete the following
steps:
•Visit bullydog, click on the Support tab located at the
top of the page and the select "technical support" from the
dropdown menu.
• If you questions aren't anwered in the FAQ's list, click on
chat with a tech and fill out the required information.
• All of the blank boxes must be filled out, including
Company. If you wish, just type in "none" under Company.