SATO M5900RVe Operator's Manual page 52

Unit 5: Troubleshooting
ERROR SIGNALS
LCD MESSAGE
MACHINE ERROR
EEPROM ERROR
HEAD ERROR
SENSOR ERROR
CARD R/W ERROR
CARD LOW BATTERY 1 long Memory card battery low
CARD NO BATTERY
HEAD OPEN
PARITY ERROR
OVERRUN ERROR
FRAMING ERROR
BUFFER OVER
PAPER END
MEDIA ERROR
CUTTER ERROR
DOWNLOAD ERROR 3 short Read/Write error
CARD COPY/FORMAT
ERROR
SATO M5900RVe Operator Manual
BEEP ERROR CONDITION
1 long Machine Error
Defective main board
1 long EEPROM read/write error
3 short Print Head is damaged
3 short Media meandering
Incorrect adjustment
Incorrcet sensor selection
Defective sensor
1 long Card not installed
Invalid number
Incorrect format
Write protected
1 long No battery inside card.
3 short Print head is open
3 short Incorrect adjustment
Incorrect cable connection
3 short Incorrect parameter
Incorrect cable connection
3 short Incorrect parameter
Incorrect cable connection
3 short Buffer overflow
Near full signal is ignored
3 short Media stock exhausted
Meandering media
Incorrect sensor adjustment
3 short Incorrect media type
Incorrect signal.
Defective sensor
3 short Cutter is jammed
Incorrect signal
Defective cutter unit
No download domain
3 short Read/Write copying error
Card not installed
No copy domain
PN 9001125A
TO CLEAR
Cycle power on/off. If the former doesn't
work, replace board.
Cycle power on/off. Reload. Replace.
Replace print head then cycle power.
Check media guides.
Cycle power and check adjustment.
Check sensor selection.
Replace sensor.
Install and cycle power.
Verify, correct.
Format card and cycle power.
Corrrect.
Replace battery and cycle power.
Install battery.
Reformat & register card.
Latch print head.
Ensure correct settings.
Ensure correct connection.
Ensure correct settings.
Ensure correct connection (Null Modem).
Ensure correct settings.
Ensure correct connection (Null Modem).
Ensure correct settings.
Cycle power on/off.
Replenish media.
Adjust media guides.
Adjust sensor, open/close head lever.
Ensure correct media stock.
Open/Close head lever.
Replace sensor.
Clean and cycle power.
Cycle power.
Replace cutter unit.
Ensure no errors in download file.
Ensure download file isn't too large.
Ensure no errors in copy file.
Ensure card is present.
Ensure copying file isn't too large.
Page 5-2