12. Network Settings
12.1 Configuring General Settings
<Network Settings> must be properly configured before you operate the NVR over a network.
Steps:
1. Enter the <Network Settings> interface: Menu >Configuration>Network
2. Select the <General> tab.
3. In the <General Settings> interface, you can configure the following settings: <Working Mode>,
<NIC Type>, < IPv4 Address>, < IPv4 Gateway>, <MTU>, <DNS DHCP> and <DNS Server>.
Note:
The valid value range of <MTU> is <500> to <9676>.
If the <DHCP Server> is available, you can click the checkbox of <DHCP> to automatically
obtain an <IP Address> and other <Network Settings> from that server.
Note:
Network Settings Interface
165