Settings; Contrast Of The Display; Settings In The Menu; Setting The Output Level Of A Retrofitted Rf Output Collector - Grundig GSS STC 160 Assembly Instruction Manual

7 s
e t ti n Gs
7.1 C
o n t r a s t
1
2
3
4
5
6
4
• Using the main power switch, (page 8, fig. 4,
• Adjust the contrast of the display using the button
7.2 s
e t t i n Gs
After the output levels of the modulator modules or the modulators have been
set, check the master output level of the RF output collector and adjust it ac-
cordingly based on the requirements of the cable system. Afterwards set the
standard of the output signal required. Set a 4-digit PIN in menu "PIN" to
protect the control panel from unauthorized access.
s
e t t i n G
• Connect the RF outputs of the modulators to the RF inputs of the RF output
collector.
• Connect the antenna test receiver to the output of the RF output collector.
• After switching on the head-end station the "Select module / channel strip"
– "SETUP BE160" menu appears in the display. Activate this menu by re-
peatedly pressing
o f t h e d i s p l ay
—> The mode indicator
i n t h e m e n u
t h e o u t p u t l e v e l
M
S
Fig. 24
3
(fig. 24) is activated.
rf
o f a r e t r o f i t t e d
if needed.
- 20 -
) switch on the head-end station.
2
(fig. 24).
2
o u t p u t C o l l e C to r
7
8
5
STC 160