Table of Contents
Advertisement
4
4.2
Assembly
1.
Unfold the Vertical Beam and locate the free
end of the Diagonal Beam into the Locking
Knob in the middle of the Vertical Beam.
Ensure that the Locking Knob is located into
the recess of the Locking Plate (as shown in
figure 1).
2.
Tighten all the knobs.
3.
Place the Laser Range-finder into the Laser
Carriage by extending the front, sprung plate
(as shown in figure 2).
4.
Carry the tool to the point on the rail opposite
the measurement target.
Place the Laser Carriage into an appropriate
Pivot Socket and lock in the socket using the
Locking knob attached (as shown in figure 2).
Switch the Laser Rangefinder on to ensure
that
laser falls onto target.
5.
Switch on Inclinometer and Laser Rangefinder.
Removing the Offset Gauge from the track
6.
Remove the equipment between locations. Fold down in reverse of
assembly.
4610-1 Issue 04
Figure1
Figure 2
Advertisement
Table of Contents
