Warranty Service Procedure; Periodic Preventative Maintenance - Temptek CF Series Instruction Manual

CF Series Portable Chiller : Air & Water-Cooled : 5 - 40 Tons
5.1

WARRANTY SERVICE PROCEDURE

A.
In the event of a problem with a chiller that can not be resolved by normal troubleshooting
procedures, the customer is invited to consult the Service Department for assistance.
The correct model number and serial number of the chiller must be available. The service
department will attempt to isolate the problem and advise repair procedures. Often times,
with the customer's input and with the machine diagnostics, problems can be determined
with "over-the-phone" consultation.
B.
If the problem is beyond the scope of "over-the-phone" consultation, and if the warranty
status of the machine is valid, the Manufacturer will contact the nearest authorized
service contractor and provide authorization to conduct an "on-site" inspection of the unit
in order to determine the course of repair. If the chiller is not covered by the warranty, the
Manufacturer will advise on the repair and recommend available service contractors.
C.
It is of the utmost importance that you provide the correct model number and serial
number of the machine in question. This will allow the Service Department to obtain the
correct manufacturing records which will help to properly troubleshoot the problem and
obtain the proper replacement parts when they are required. This information is stamped
on the data tag that is attached to the electrical enclosure of each machine.
D. The Service Department must be notified prior to any repair or service of a warranty
nature. Warranty claims will not be honored without prior authorization.
5.2

PERIODIC PREVENTATIVE MAINTENANCE

A.
Lubricate all motors. Note that some motors are supplied with sealed bearings.
B. Tighten all wire terminals.
C.
Clean and check motor starter and contactor contacts.
D. Check safety switch settings.
E.
Clean condenser fins of dust and dirt (air cooled models only).
F. Back flush evaporator.
G.
Check glycol/water solution ratio for operating temperature.
H. Check system for leaks.
I.
Refrigerant sight glass: Check for bubbles when compressor is operating at 100%. Check
the moisture indicator for a color other than green.
J.
Clean unit.
TEMPTEK, INC.
525 East Stop 18 Road Greenwood, Indiana 46142
317-887-6352 Fax: 317-881-1277
Email: service@Temptek.com
Page: 44