General Pipe Cleaners Gen-Eye Micro-Scope2 Operating Instructions Manual page 10

®
Gen-Eye Micro-Scope2
TROUBLESHOOTING, continued
Battery Won't Hold Charge
NOTE: Command Module is shipped without a charge.
Charge the Command Module for 12 hours or overnight
before first use.

Allow 5 hours to fully recharge battery.

Cold weather can reduce battery life. Keep unit warm in cold
weather.

Do not charge the battery in extreme weather (temperatures
below 30°F or above 104°F.

When charging via DC, you must use the AC inverter.

Battery is worn out and need to be replaced.

Disconnect the main power source and contact the factory ser-
vice department.
General Wire Spring Co,
1101 Thompson Avenue
McKees Rocks, PA 15136
412-771-6300
© General Wire Spring Co. 2018
Video Pipe Inspection/Location System
www.drainbrain.com
C-GEMS2OI-1018