Preparation And Wiring Diagrams; Wiring Diagram - Delta 110HLEDNL Assembly Instructions Manual

PREPARATION
Tools Required for Assembly (not included): Hammer,
Flathead Screwdriver, Wire Nuts, Nails, Duct Tape,
Phillips Head Screwdriver, Utility Knife
Helpful Tools (not included): Electric Drill, Drill Bits
WARNING: Turn off electricity at breaker box
before beginning installation.
Carefully remove unit from carton.
Check area above installation location to be sure that
wiring can run to the planned location and that duct
proper ventilation.
Inspect duct work and wiring before proceeding with
installation.
Before installation, provide inspection and future
maintenance access at a location that will not
interfere with installation work.
You may need the help of a second person to install
this fan: one person on the attic side and one on the
room side.
Note: Installations may vary depending on how the
previous bath fan was installed. Supplies necessary
for the installation of your bath fan are not all included.
However, most are available at your local home
improvement or hardware store.

WIRING DIAGRAM

JUNCTION BOX
RED
YELLOW
ON/OFF SWITCH
(purchase separately)
LIGHT POWER
NIGHT- MODE
LIGHT SWITCH SWITCH SWITCH
SWITCH
SWITCH BOX
OFF
BLACK
L
ON
WHITE
POWER SWITCH
N
BLUE
L
HI
WHITE
MODE SWITCH
N
OFF
RED
L
ON
WHITE
LIGHT SWITCH
N
OFF
YELLOW
L
ON
WHITE
NIGHT-LIGHT SWITCH
N
GREEN
GRD
BLUE BLACK
GROUND WHITE
(bare)
SWITCH BOX
WIRING
PLATE
120 VAC
LINE IN
Proper insulation around the fan to minimize building
heat loss and gain. 4" circular duct is recommended
for installation. The ducting from this fan to the
noise and energy use of the fan. Use the shortest,
straightest duct routing possible for best performance,
and avoid installing the fan with smaller ducts than
recommended. Insulation around the ducts can reduce
energy loss and inhibit mold growth. Fans installed with
Short piece of flexible
duct helps alignment
and absorbs
sound
Fan housing
Seal gap
Caulk termination
around
to duct
housing
Locate unit above (GFCI-protected circuit required)
or within 5 feet of the shower head.
Locate unit away from heating or cooling sources
which can affect humidity levels.
Do not locate near window. Unit may respond to the
outdoor humidity level.
Unit must be installed in ceiling to properly sense
moisture.
proper sensing.
The fan will operate most efficiently when located
where the shortest possible duct run and minimum
number of elbows will be needed.
Use a roof cap or wall cap that has a built-in damper
to reduce backdrafts.
External timer/dimmer switch can be used please
contact Delta Breez customer service and consult
with a licensed electrician for compatibility
4
Roof cap
(with built-in
damper)
or
Wall cap Wall cap
(with built-in (with built-in
damper) damper)