ANT+ Sensors
Replacing
the GSC 10
Battery
The GSC 10 contains a user-
replaceable CR2032 battery.
NOTE: Contact your local waste
disposal department to properly
dispose of batteries.
1. Locate the circular battery cover on
the side of the GSC 10.
Battery
CR2032
battery
2. Use a coin to twist the cover
counter-clockwise until it is loose
enough to remove (arrow points to
unlocked).
3. Remove the cover and battery.
4. Wait 30 seconds.
5. Insert the new battery with the
positive side facing up.
NOTE: Be careful not to damage
or lose the O-ring gasket on the
cover.
6. Use a coin to twist the cover back
into place (arrow points to locked).
Battery
Arrow
Third-Party ANT+ Sensors
For a list of third-party ANT+ sensors
that are compatible with the Edge, go
Edge 800 Owner's Manual
Unlocked