Using The Gsc 10 - Garmin EDGE 800 Owner's Manual

Using the GSC 10
1. Turn on the Edge.
2. Bring the Edge within range (3 m)
of the GSC 10.
3. Press and hold MENU.
4. Select Settings > Bike Settings >
[Bike 1] > ANT+ Spd/Cad.
5. Select Yes > Rescan.
6. Press BACK to return to the main
menu.
When the GSC 10 is paired, a
message appears, and the
speed and cadence icons appear
solid on the status page.
7. Customize optional data fields
(page 39).
8. Go for a ride.
About the GSC 10
Cadence data from the GSC 10 is
always recorded. If there is no GSC 10
paired, GPS data is used to calculate
Edge 800 Owner's Manual
the speed and distance.
Cadence is your rate of pedaling or
"spinning" measured by the number of
revolutions of the crank arm per minute
(rpm). There are two sensors on the
GSC 10: one for cadence and one for
speed.
For information about cadence alerts,
see page 6.
Non-Zero Averaging for
Cadence Data
The non-zero data-averaging setting
is available if you are training with an
optional cadence sensor. The default
setting is to exclude zero values that
occur when you are not pedaling.
To turn the non-zero averaging
on or off, select MENU >
Bike Settings > Data Averaging >
Cadence.
ANT+ Sensors
>