Video Input; Selecting Input Source - Sanyo PLV-75 Owner's Manual

VIDEO INPUT

DIRECT OPERATION
Select INPUT source by pressing INPUT button on Top Control or on
Remote Control Unit.
Select INPUT source by pressing INPUT 1, INPUT 2 or INPUT 3
button on Remote Control Unit.
If projector cannot reproduce proper image, select correct input source
through MENU OPERATION (see below).
When connecting to those equipment, select a type of Video
source in SOURCE SELECT Menu.
1 Press MENU button and ON-SCREEN MENU will appear. Press
POINT LEFT/RIGHT buttons to move a red frame pointer to
INPUT Menu icon.
2
Press POINT UP/DOWN buttons to move a red arrow pointer to
Input 2 and then press SELECT button. Source Select Menu will
appear.
3 Move a pointer to source that you want to select and then press
SELECT button.
When video input signal is connected to VIDEO jack,
Video
select Video.
When video input signal is connected to Y-Pb/Cb-
Y,Pb/Cb,Pr/Cr
Pr/Cr jacks, select Y, Pb/Cb, Pr/Cr.
NOTE;
INPUT SOURCE changes if the INPUT 2 button on Remote Control
Unit is pressed.
When connecting to those equipment, select a type of Video
source in SOURCE SELECT (VIDEO) Menu.
1 Press MENU button and ON-SCREEN MENU will appear. Press
POINT LEFT/RIGHT buttons to move a red frame pointer to
INPUT Menu icon.
2
Press POINT UP/DOWN buttons to move a red arrow pointer to
Input 3 and then press SELECT button. Source Select Menu will
appear.
3 Move a pointer to source that you want to select and then press
SELECT button.
When video input signal is connected to VIDEO jack,
Video
select Video.
When video input signal is connected to Y-Pb/Cb-
Y,Pb/Cb,Pr/Cr
Pr/Cr jacks, select Y, Pb/Cb, Pr/Cr.
When video input signal is connected to S-VIDEO jack,
S-Video
select S-Video.
NOTE;
INPUT SOURCE changes if the INPUT 3 button on Remote Control
Unit is pressed.

SELECTING INPUT SOURCE

SELECTING INPUT SOURCE
WHEN SELECT INPUT 2 (5 BNC INPUT JACKS )
WHEN SELECT INPUT 3 (AV TERMINALS )
INPUT button
Input 1
Input 2
Input 3
INPUT MENU
Input
SVGA 1
INPUT Menu icon
Input 1
Input 2
Move a pointer (red arrow) to
Input 3
Input 2 and press SELECT
button.
Input 2
Source Select Menu
Move a pointer (red
arrow) to Video or
Y, Pb/Cb, Pr/Cr and
press SELECT button.
INPUT MENU
Input SVGA 1
Input 1 INPUT Menu icon
Input 2
Move a pointer (red arrow) to
Input 3
Input 3 and press SELECT
button.
Input 3
Source Select Menu (VIDEO)
Move a pointer (red arrow)
to source
SELECT button.
and press
31