Manual Pc Adjustment - Sanyo PLV-75 Owner's Manual

This projector can automatically tune to display signals from most personal computers currently distributed. However, some
computers employ special signal formats which are different from standard ones and may not be tuned by Multi-Scan system
of this projector. If this happens, projector cannot reproduce a proper image and image may be recognized as a flickering
picture, a non-synchronized picture, a non-centered picture or a skewed picture.
This projector has a Manual PC Adjustment to enable you to precisely adjust several parameters to match with those special
signal formats. This projector has 10 independent memory areas to memorize those parameters manually adjusted. This
enables you to recall setting for a specific computer whenever you use it.
Note : This PC ADJUST Menu cannot be operated when in digital signal input on DVI terminal is selected on PC SYSTEM
MENU (P24).
1 Press MENU button and ON-SCREEN MENU will appear. Press
POINT LEFT/RIGHT buttons to move a red frame pointer to PC
ADJUST Menu icon.
2
Press POINT UP/DOWN buttons to move a red frame pointer to
item that you want to adjust and then press SELECT button.
Adjustment dialog box will appear. Press POINT LEFT/RIGHT
buttons to adjust value.
Fine sync
Adjusts an image as necessary to eliminate flicker from display.
Press POINT LEFT/RIGHT buttons to adjust value. (From 0 to 31.)
Total dots
Adjust the number of total dots in one horizontal period. Press
POINT LEFT/RIGHT buttons and adjust number to match your PC
image.
Position H
Adjusts horizontal picture position. Press POINT LEFT/RIGHT
buttons to adjust position.
Position V
Adjusts vertical picture position. Press POINT LEFT/RIGHT
button(s) to adjust position.
Current mode
Press SELECT button to show information of computer selected.
Clamp
Adjusts clamp position. When image has a dark bar(s), try this
adjustment.
Display area H
Adjustment of horizontal area displayed with this projector. Press
POINT LEFT/RIGHT buttons to decrease/increase value and then
press SELECT button.
Display area V
Adjustment of vertical area displayed with this projector. Press
POINT LEFT/RIGHT buttons to decrease/increase value and then
press SELECT button.

MANUAL PC ADJUSTMENT

COMPUTER INPUT
PC ADJUST MENU
Auto PC adj.
SVGA1
PC ADJUST Menu icon
Move a red frame pointer to item
and press SELECT button.
Fine sync
Mode 1 Stored
Selected Mode
Press POINT LEFT/RIGHT
buttons to adjust value.
Press SELECT button at this icon to
adjust "Clamp," "Display area H" or
set "Display area V."
Press SELECT button at this icon
to display previous items.
Shows status
(Stored / Free) of
selected Mode.
Current mode
Press SELECT button at
Current mode icon to
show information of
computer connected.
27