Select Computer System Manually - Sanyo PLV-75 Owner's Manual

WHEN SELECT INPUT 2 (5 BNC INPUT JACKS )
When connect a computer output [5 BNC Type (Green, Blue, Red,
Horiz. Sync and Vert. Sync.)] from a computer to G, B, R, H/HV and V
jacks.
1 Press MENU button and ON-SCREEN MENU will appear. Press
POINT LEFT/RIGHT buttons to move a red frame pointer to
INPUT Menu icon.
2 Press POINT UP/DOWN buttons to move a red arrow pointer to
Input 2 and then press SELECT button. Source Select Menu will
appear.
3 Press POINT UP/DOWN buttons and a red-arrow icon will
appear. Move arrow to "RGB", and then press SELECT button.
NOTE;
INPUT SOURCE changes if the INPUT 2 button on Remote Control
Unit is pressed.
This projector automatically tunes to most different types of computers based on VGA, SVGA, XGA, SXGA, SXGA+, WXGA
or UXGA (refer to "COMPATIBLE COMPUTER SPECIFICATION" on pages 52-53). When a computer is selected, this
projector automatically tunes to incoming signal and projects the proper image without any special setting. (Some
computers need to be set manually.)
The projector displays one of the Auto, -----, Mode 1/2/3/4/5/6/7/8/9/10, or the system provided in the projector.
When projector cannot recognize connected signal as PC
Auto
system provided in this projector, Auto PC Adjustment
function operates to adjust projector and message "Auto"
is displayed on SYSTEM Menu icon.
When image is not provided properly, manual adjustment
is required. (Refer to P27 and 28.)
There is no signal input from computer. Make sure
––––
connection of computer and a projector is set correctly.
(Refer to TROUBLESHOOTING on page 48.)
User preset adjustment in MANUAL PC ADJUSTMENT.
Mode 1
Adjustment data can be stored in the Mode 1-10.
Computer systems provided in the projector. The
SVGA 1
projector chooses proper system and displays it.
✽
Mode 1 and SVGA 1 are examples.

SELECT COMPUTER SYSTEM MANUALLY

This projector automatically selects PC system among those provided
in this projector and PC system can be also selected manually.
1 Press MENU button and ON-SCREEN MENU will appear. Press
POINT LEFT/RIGHT buttons to move a red frame pointer to PC
SYSTEM Menu icon.
2 Press POINT UP/DOWN buttons to move a red arrow pointer to
system that you want to set, and then press SELECT button.
AUTOMATIC MULTI-SCAN SYSTEM
COMPUTER INPUT
INPUT MENU
Input
SVGA1
INPUT Menu icon
Input 1
Input 2
Move a pointer (red arrow) to
Input 3
Input 2 and press SELECT
button.
Input 2
Source Select Menu
Move a pointer (red arrow)
to RGB and press SELECT
button.
PC SYSTEM MENU
Mode 1
System
PC SYSTEM Menu icon
Displays system being
selected.
PC SYSTEM MENU
System Mode 1
Mode 1
PC SYSTEM Menu icon
Mode 2
Displays system being selected.
SVGA 1
Systems on this dialog box can
SVGA 2
be selected.
SVGA 3
Custom Mode (1~10) set in PC
ADJUST Menu. (P27, 28)
25