Lamp Replacement - Sanyo PLC-XW50 Owner's Manual

Maintenance and Cleaning

Lamp Replacement

When the life of the projection lamp of this projector
draws to an end, the LAMP REPLACE indicator emits
a yellow light. If this indicator lights yellow, replace the
lamp with a new one promptly.
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER
CAUTION
Allow a projector to cool, for at least 45
minutes before you open the Lamp cover.
The inside of the projector can become very
hot.
Follow these steps to replace the lamp.
1
Turn off the projector and disconnect the AC power
cord. Allow the projector to cool for at least 45
minutes.
2
Loosen the screw with a screwdriver, and remove
the lamp cover.
3
Loosen the 3 screws of the lamp with a screwdriver
and lift the lamp out of the projector by using the
built in handles.
4
Replace the lamp with a new one and secure it
with the 3 screws. Make sure that the lamp is set
properly. Replace the lamp cover and tighten the
screw.
5
Connect the AC power cord to the projector and
turn on the projector.
6
Reset the lamp replacement counter .
See "Lamp Replacement Counter" on the next
page .
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give
the following information to the dealer.
● Model No. of your projector
● Replacement Lamp Type No.
54
TOP CONTROL
CAUTION
For continued safety, replace with a lamp of
the same type. Do not drop a lamp or touch
a glass bulb! The glass can shatter and
may cause injury.
Lamp Cover
Lamp
Screw
: PLC-XW50/PLC-XW55
: POA-LMP107
(Service Parts No. 610 330 4564)
T h i s i n d i c a t o r i s
yellow when the life
of the projection lamp
draws to an end.
Screw
Screw
Screw
Handles