Table of Contents
Advertisement
CONNECTING PROJECTOR
Cables used for connection
• DVI-VGA Cable
• Control Cable for PS/2 Port
• VGA Cable (HDB 15 pin)
• DVI-Digital Cable (for Single Link T.M.D.S.)
DVI-VGA Cable and Control Cable for PS/2 Port are supplied with this projector.
Monitor Output
MAC Adapter
Set slide switches
according to the
chart below.
DVI-VGA Cable
COMPUTER IN DVI-I
N MAC ADAPTER
A Macintosh adapter may be
required for use when some
Macintosh computers. Contact the
dealer where you purchased this
projector.
NOTE :
When connecting the cable, the power
cords of both the projector and the external
equipment should be disconnected from
AC outlet.
peripheral equipment on before the
computer is switched on.
12
CONNECTING TO COMPUTER
IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA)
Monitor Output
Monitor Input
VGA
Cable
DVI Cable
COMPUTER IN DVI-I
MONITOR OUT
COMPUTER IN
DVI - I
R – AUDIO IN – L
S – VIDEO
MCI / WI
Turn the projector and
• Control Cable for Serial Port or ADB Port
• USB Cable
• MAC Adapter (When connecting to Macintosh computer)
• Audio Cables (RCA x 2 and Mini Plug (stereo) x 1)
Desktop type
Audio Output
USB port
Audio
USB
Cable
Cable
(stereo)
AUDIO IN COMPUTER
USB
VIDEO
Y – Pb / Cb – Pr / Cr
(MONO)
AUDIO IN
R –
AUDIO OUT
– L
COMPUTER
RESET
MONITOR OUT
USB
CONTROL PORT
AUDIO OUT
Audio Input
External Audio Equipment
Audio Amplifier
Laptop type
Serial port
PS/2 port
ADB port
Control Cable
Control Cable
Control Cable
for Serial Port
for PS/2 Port
for ADB Port
Terminal
Terminal
Terminal
CONTROL PORT
Use one of these Control
Cables corresponding with
the terminal of your
computer.
Terminals
of the Projector
Audio Cable
(stereo)
Audio Speaker
(stereo)
Advertisement
Table of Contents
