Rear Terminal
① CONTROL PORT
When the projector is controlled by a computer,
connect to this jack with serial control cable.
②
COMPUTER IN 1 / COMPONENT IN
Connect output signal from a computer, RGB scart
21-pin video output or component video output to
this terminal (pp.16,18).
③
MONITOR OUT
This terminal can be used to output the incoming
analog RGB signal from COMPUTER IN 2 / DVI-I
terminal or COMPUTER IN 1/COMPONENT IN
terminal to the other monitor (p.16).
④
COMPUTER IN / DVI-I
Connect computer output (Digital/Analog DVI-I type)
to this terminal (p.16).
⑤
LAN Connection Terminal
Connect the LAN cable (refer to the owner's manual
"Network Set-up and Operation").
⑥ USB Connector (Series A)
Connect the USB cable (refer to the owner's manual
"Network Set-up and Operation").
⑦ S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.17).
①
②
⑫
⑪
Part Names and Functions
③
④
⑩
⑨
⑧
⑦
⑧
AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.16-18).
This terminal outputs sound from AUDIO IN
terminal (⑨ or ⑩).
⑨
COMPUTER 1 / COMPUTER AUDIO IN
Connect the audio output (stereo) from a computer
or video equipment connected to ② or ④ to this
jack (pp16, 18).
⑩
AUDIO IN
Connect the audio output signal from video
equipment connected to ⑦ or ⑪ to this jack. For a
mono audio signal (a single audio jack), connect it
to the L (MONO) jack (p.17).
⑪
VIDEO IN
Connect the composite video output signal to this
jack (p.17).
⑫ USB Connector (Series B)
In order to operate the computer with the remote
control and use the PAGE
remote control during a presentation, connect the
USB port of the computer to the USB terminal with
a USB cable (not supplied) (p.16).
⑤
⑥
buttons on the
▲▼