Replacement Membrane - P. Energy L150A User And Maintenance Handbook

......................................................
5.1.2 ORDINARY MAINTENANCE REPLACEMENT MEMBRANE
When it's necessary
1- with the laminator cover close ,opening the
hook, and remove membrane.
2-heat the plate at 140°C, place the new
membrane above the heating plate and wait for 10
minutes
P.Energy P.Energy P.Energy P.Energy
20mm
3-RePositioning the frame and the new membrane
at 20mm from the cover
Reassemble the frame closing the hook.(first in the
rear side, then in the left and in the right side, for
the last the front side)
USER AND MAINTENANCE HANDBOOK L150A
1
4- Open the cover and Watch the membane state,
it must be well placed over the entire surface.
If it's not well placed,
1-open one hook
2- pull the membrane with flat pliers
3-close the hook
2
25 - 30