Table Of Contents - Beckett CF 500/800 Instruction Manual

Before you begin . . .
The following resources will give you additional
information for your installation. We suggest that
you consult these resources whenever possible. Pay
particular attention to the appliance manufacturer's
instructions.
Appliance manufacturer's instructions -Always
follow the appliance manufacturer's instructions
for burner installation, equipment and set-up.
1-800-OIL-BURN - Beckett's technical services
hot-line.
www.beckettcorp.com - Beckett's website.
To the Owner:
Thank you for purchasing a Beckett burner
for use with your heating appliance. Please pay
attention to the Safety Warnings contained within
this instruction manual. Keep this manual for your
records and provide it to your qualifi ed service
agency for use in professionally setting up and
maintaining your oil burner.
Your Beckett burner will provide years of effi cient
operation if it is professionally installed and
maintained by a qualifi ed service technician. If at
any time the burner does not appear to be operating
properly, immediately contact your qualifi ed
service agency for consultation.
We recommend annual inspection/service of
your oil heating system by a qualifi ed service
agency.
2

Table of Contents

General Information
Hazard Defi nitions ..........................................................3
Agency approvals ..........................................................3
Specifi cations .................................................................3
Owner's Responsibility ..................................................4
Installer/Service Agency Responsibility .........................4
Pre-installation checklist
Combustion air supply ...................................................4
Clearances .....................................................................4
Fuel supply .....................................................................5
Nozzle pressure .............................................................5
Electrical supply .............................................................5
Vent system ...................................................................5
Verify burner components ..............................................6
Verify fi ring rate ..............................................................6
Verify air tube .................................................................6
Stray light lockout ...........................................................7
Dust and Moisture ..........................................................7
Mount the burner
...................................................
Mount fl anges on air tubes .............................................7
Mount air tube to burner .................................................8
Install Nozzle ..................................................................8
Check Electrode Settings ...............................................8
Install Nozzle Line Assembly .........................................8
Set Dimension Z ............................................................8
Insert Burner ..................................................................8
Fuel Unit By-pass Plug ..................................................9
Oil Supply/Return Lines .................................................9
Burner Fuel Flow ............................................................9
Wire the burner
.......................................................
Sequence of operation .......................................10
Resetting to cad cell .............................................10
Prepare the burner for start-up
Start-up checklist ......................................................... 11
Z Dimension ................................................................. 11
Initial head position ...................................................... 11
Initial air settings ..........................................................12
Set appliance limit controls ..........................................12
Prepare the fuel unit for air venting ..............................12
Start the burner
..................................................
Starting the burner and venting air ..............................12
CAD Cell resistance check ..........................................13
Set combustion using instruments ...............................13
Maintenance and Service
Annual Service .............................................................14
Monthly maintenance ...................................................14
Replacement Parts
Warranty
..................................................
R09, Printed in the USA 01/08
Form 6104BCF5
..............................................
.....................................
......................
.....................................
.................................................
Back Cover
2-4
4-7
7-9
10
11-12
12-13
14
15