Indicators And Projector Condition - Sanyo PLC-SW30 Owner's Manual

Appendix

Indicators and Projector Condition

Check the indicators for projector condition.
Indicators
WARNING
POWER
red/green
• • • lights green.
✽ When the life of the projection lamp draws to an end, the LAMP REPLACE indicator lights yellow. When this indicator lights
yellow, replace the projection lamp with a new one promptly. Reset the Lamp replace counter after replacement of the lamp.
☞
( P40-41)
46
LAMP
REPLACE
red yellow
The projector is OFF. (The AC power cord is unplugged.)
The projector is preparing for stand-by or the projection lamp is being
✽
cooled down. The projector cannot be turned on until cooling is completed.
✽
The projector is ready to be turned on with the POWER ON-OFF button.
✽
The projector is operating normally.
✽
The projector is in the Power management mode.
The temperature inside the projector is abnormally high. The projector
cannot be turned on. When the projector is cooled down enough and the
✽
temperature returns to normal, the POWER indicator lights red and the
projector can be turned on. (The WARNING indicator keeps flashing.)
Check and clean the Air filter.
The projector has been cooled down enough and the temperature returns
✽
to normal. When turning on the projector, the WARNING indicator stops
flashing. Check and clean the air filters.
The projector detects an abnormal condition and cannot be turned on.
Unplug the AC power cord and plug it again to turn on the projector. If the
✽
projector is turned off again, disconnect the AC power cord and contact the
dealer or the service center for service and checkup. Do not leave the pro-
jector on. It may cause electric shock or a fire hazard.
• • • flashes green.
Projector Condition
• • • flashes red.
• • • lights red.
• • • off